Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM E88-91(1996)

Standard Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition

Standard Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition E0088-91R96 ASTM|E0088-91R96|en-US Standard Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition Standard new BOS Vol. 03.05 Committee E01
$ 73.00 In stock

Scope

1.1 This practice covers the sampling, for the determination of chemical composition (Note 1) of nonferrous metals and alloys in cast form for remelting or mechanical working.

1.1.1 Refer to Practice E255 for copper and copper alloys.

Note 1--The selection of correct portions of material and the preparation of a representative sample from such portions are necessary prerequisites to every analysis, the analysis being of no value unless the sample actually represents the average composition of the material from which it was selected.

1.2 When agreed upon between the purchaser and the manufacturer, the heat sample and analysis may be accepted as representative of the composition of the metal. In such cases, each lot must be properly identified with the heats from which it was made.

1.3 This practice is intended to cover the general principles of sampling applicable to nonferrous metals in cast form and is not intended to supersede or replace existing specification requirements for sampling of a particular material.

1.4 The values stated in inch-pound units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.05
Developed by Subcommittee: E01.05
Pages: 2
DOI: 10.1520/E0088-91R96