Standard Active Last Updated: Jan 20, 2020 Track Document
ASTM D8260-20

Standard Specification for Hot-Applied Asphalt Aggregate-Filled Mastic

Standard Specification for Hot-Applied Asphalt Aggregate-Filled Mastic D8260-20 ASTM|D8260-20|en-US Standard Specification for Hot-Applied Asphalt Aggregate-Filled Mastic Standard new BOS Vol. 04.03 Committee D04
$ 63.00 In stock


1.1 This specification covers hot-applied asphalt aggregate-filled mastics for repairing distresses in asphalt pavements and hydraulic concrete pavements. These distresses include, but are not limited to: depressions, wide cracks not suitable for crack sealing, pot holes, corner breaks and longitudinal joint distresses, and other repairs smaller than those requiring remove and replace procedures.

1.2 The values stated in SI units are to be regarded as standard. No other units are included in this standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.33
Pages: 5
DOI: 10.1520/D8260-20
ICS Code: 93.080.20