Standard Active Last Updated: Sep 19, 2023 Track Document
ASTM D8039-16(2023)

Standard Specification for Heat Transfer Fluids (HTF) for Heating and Air Conditioning (HVAC) Systems

Standard Specification for Heat Transfer Fluids (HTF) for Heating and Air Conditioning (HVAC) Systems D8039-16R23 ASTM|D8039-16R23|en-US Standard Specification for Heat Transfer Fluids (HTF) for Heating and Air Conditioning (HVAC) Systems Standard new BOS Vol. 15.05 Committee D15
$ 61.00 In stock
ASTM International

Abstract

This specification establishes the requirements for ethylene glycol, propylene glycol, 1,3 propanediol, and glycerin base heat transfer fluids (HTF) used in heating and air conditioning (HVAC) systems. When concentrates are used at up to 65% concentration by weight in water, or when prediluted heat transfer fluids (30% by weight minimum) are used without further dilution, they will function effectively to provide protection against freezing, and corrosion. The HTFs governed by this specification are categorized according to the primary base of freeze depressant used: I (ethylene glycol), II (propylene glycol), III (1,3-propanediol), and IV (glycerin).

Scope

1.1 This specification covers the requirements for ethylene glycol, propylene glycol, 1,3 propanediol as well as glycerin base heat transfer fluids (HTF) used in heating and air conditioning (HVAC) systems. When concentrates are used at up to 65 % concentration by weight in water, or when prediluted heat transfer fluids (30 % by weight minimum) are used without further dilution, they will function effectively to provide protection against freezing, and corrosion.

1.2 The fluids described in this specification are not appropriate for use in systems where internal combustion engines (gasoline, diesel, or CNG/LPG) are used.

1.3 The heat transfer fluids governed by this specification are categorized as follows by the primary base of freeze depressant used:

Heat Transfer
Fluid Type

Description

I

 

Ethylene glycol

II

 

Propylene glycol

III

 

1,3-Propanediol

IV

 

Glycerin

1.4 Heat transfer fluids meeting this specification shall be tested and fully comply with requirements listed in Table 1.

Note 1: This specification is based on the knowledge of the performance of heat transfer fluids prepared from new or virgin ingredients. This specification shall also apply to heat transfer fluids prepared using materials generated from recycled or reprocessed ingredients, provided that these ingredients meet the requirements of Specifications E1177 and D7388 for Glycols and Specification D7640 for Glycerin.

Note 2: This specification addresses concentrated inhibited glycols and glycerol that will be mixed with water for use in various climates and prediluted heat transfer fluids (HTF) that are factory-blended with purified water. A table of estimated freeze protection temperatures at appropriate dilutions is provided in Appendix X1.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.05
Developed by Subcommittee: D15.30
Pages: 4
DOI: 10.1520/D8039-16R23
ICS Code: 71.100.45; 91.140.10; 91.140.30