Standard Withdrawn, No replacement   Last Updated: Oct 05, 2021
ASTM D7710-14

Standard Test Method for Determination of Volume and Density of Rigid and Irregularly Shaped Molded Cellular Materials (Withdrawn 2021)

Significance and Use

4.1 The test procedure provides a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications and for special purposes.

4.2 The data obtained by this test method is applicable to the material under the conditions of this particular test and are not necessarily the same as obtained under other environments in use.

Scope

1.1 This test method is used to determine the volume and density of irregularly shaped molded products.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center