Standard Active Last Updated: Jan 06, 2022
ASTM D7650-21

Standard Practice for Sampling of Particulate Matter in High Pressure Gaseous Fuels with an In-Stream Filter

Significance and Use

5.1 This sampling procedure is used to collect a particulate filter sample containing particulates 0.2 µm or larger in size to be used to measure the size and concentration of particulates in a gaseous fuel stream.

Scope

1.1 This practice is primarily for sampling particulates in gaseous fuels up to a nominal working pressure (NWP) of 70 MPa (10 152 psi) using an in-stream filter. This practice describes sampling apparatus design, operating procedures, and quality control procedures required to obtain the stated levels of precision and accuracy.

1.2 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.06
Developed by Subcommittee: D03.14
Pages: 6
DOI: 10.1520/D7650-21
ICS Code: 27.075