Standard Active Last Updated: Jul 14, 2022 Track Document
ASTM D7633-13(2022)

Standard Test Method for Carbon Black—Carbon Content

Standard Test Method for Carbon Black—Carbon Content D7633-13R22 ASTM|D7633-13R22|en-US Standard Test Method for Carbon Black—Carbon Content Standard new BOS Vol. 09.01 Committee D24
$ 50.00 In stock

Significance and Use

4.1 The total carbon content of a carbon black is a requirement for the calculation and reporting of carbon dioxide emissions. It can also be used in calculations to estimate yield of the process.


1.1 This test method covers the instrumental determination of carbon content in a carbon black sample. Values obtained represent the total carbon content.

1.2 The method is applicable to tread, carcass and specialty type carbon blacks obtained from partial combustion or thermal decomposition processes, which typically contain 95 to 100 % carbon.

1.3 The results of these tests can be expressed as mass % carbon.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 09.01
Developed by Subcommittee: D24.66
Pages: 3
DOI: 10.1520/D7633-13R22
ICS Code: 71.060.10