Standard Historical Last Updated: Jun 06, 2013
ASTM D7611/D7611M-10

Standard Practice for Coding Plastic Manufactured Articles for Resin Identification

Significance and Use

Resin Identification Codes are used solely to identify the plastic resin used in a manufactured article.

Resin Identification Codes are not recycle codes. The use of a Resin Identification Code on a manufactured plastic article does not imply that the article is recycled or that there are systems in place to effectively process the article for reclamation or re-use. The term recyclable or other environmental claims shall not be placed in proximity to the Code.

This practice is based upon the system developed in 1988 by the Society of the Plastics Industry, Inc (SPI).

Scope

1.1 This practice stipulates the types, names and sizes of Codes for those material types specified in Table 1.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems is likely to result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.03
Developed by Subcommittee: D20.95
Pages: 4
DOI: 10.1520/D7611_D7611M-10
ICS Code: 83.140.01