Standard Historical Last Updated: Mar 17, 2022 Track Document
ASTM D7469-21

Standard Test Methods for End Joints in Structural Wood Products

Standard Test Methods for End Joints in Structural Wood Products D7469-21 ASTM|D7469-21|en-US Standard Test Methods for End Joints in Structural Wood Products Standard new BOS Vol. 04.10 Committee D07
$ 83.00 In stock

Significance and Use

4.1 These test methods are applicable to specimens with or without specific conditioning regimens. Tests are permitted to be performed on specimens that are not at moisture equilibrium, such as under production conditions in a plant, or on specimens that have been conditioned to specified moisture content or durability conditioning prior to testing.

4.2 These test methods can be used as follows:

4.2.1 To standardize the determination of strength properties for the material and joint being tested.

4.2.2 To investigate the effect of parameters that may influence the structural capacity of the joint, such as joint profile, adhesive type, moisture content, temperature, and strength-reducing characteristics in the assembly.

4.3 These test methods do not intend to address all possible exposure or performance expectations of end joints. The following are some performance characteristics not considered:

4.3.1 Long-term strength and permanence of the wood adhesive.

4.3.2 Time dependent mechanical properties of the joint.

4.3.3 Elevated temperature performance of the joint.


1.1 This standard provides test methods for evaluating the structural capacity and integrity of end joints in structural wood products.

1.2 Off-line test methods include: (1) Axial Tension, (2) Bending, and (3) Cyclic Delamination.

1.3 In-line test methods include: (1) Tension Proofload and (2) Bending Proofload.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.10
Developed by Subcommittee: D07.01
Pages: 17
DOI: 10.1520/D7469-21
ICS Code: 91.080.20