Standard Historical Last Updated: Aug 29, 2019 Track Document
ASTM D7293-12

Standard Specification for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI)

Standard Specification for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI) D7293-12 ASTM|D7293-12|en-US Standard Specification for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI) Standard new BOS Vol. 08.03 Committee D20
$ 83.00 In stock

Abstract

This test method covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins. The type of PEI extruded shape shall be categorized by class depending on composition. Every class of PEI shape shall be categorized into one grade for virgin unfilled products. The type and class shall be further differentiated based on dimensional tolerances and dimensional stability (based on elevated temperature excursion testing). Grades 1 and 2 materials are produced with the closest commercial tolerances and lowest stress levels for machined parts. The type, class, and grade is further differentiated based on dimensional stability (elevated temperature excursion test). Tensile strength at break, elongation at break, flexural modulus, izod impact, and tensile modulus (tangent) shall be tested to meet the requirements prescribed. The plate specimens, sheet specimens, rod specimens, and tubular bar specimens shall be tested to meet the requirements prescribed.

Scope

1.1 This specification covers requirements and test methods for the dimensions, workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins.

1.2 The properties included in this specification are those required for the compositions covered. It is possible that other requirements will be necessary to identify particular characteristics important to specialized applications. These shall be specified by using the suffixes as given in Section 5.

1.3 This specification does not allow for the use of recycled plastics (as defined in Guide D7209).

1.4 The values stated in English units are regarded as standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1 and Table S-PEI.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1There is no known ISO equivalent to this standard.
Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.03
Developed by Subcommittee: D20.15
Pages: 6
DOI: 10.1520/D7293-12
ICS Code: 83.080.20