Standard Active Last Updated: Nov 06, 2024 Track Document
ASTM D6828-02(2024)

Standard Test Method for Stiffness of Fabric by Blade/Slot Procedure

Standard Test Method for Stiffness of Fabric by Blade/Slot Procedure D6828-02R24 ASTM|D6828-02R24|en-US Standard Test Method for Stiffness of Fabric by Blade/Slot Procedure Standard new BOS Vol. 07.02 Committee D13
$ 69.00 In stock
ASTM International

Significance and Use

5.1 This test method is considered satisfactory for quality control testing.

5.2 If there are differences of practical significance between reported test results for two laboratories, comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use test samples as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal number to each laboratory for testing. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future results for the source material must be adjusted in consideration of the known bias.

5.3 The stiffness of fabric relates to its resistance to bending with further processing and use. It measures the fiber and yarn bending capabilities, the cohesion of individual fibers and yarns relative to their displacement and binders or finishes that hold them in place.

Scope

1.1 This test method covers the determination of the stiffness of fabrics by measuring the force required to push a specimen into a slot of predetermined width with a metal blade working at a predetermined capacity.

Note 1: For other methods for testing stiffness, refer to Test Methods D1388, D4032, and D5732.

1.2 This test method is applicable to fabrics of any fiber content whose stiffness does not exceed the capacity of the Penetrator Beam apparatus. Specimens can be taken from fabrics, rolls, or end products.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.02
Developed by Subcommittee: D13.60
Pages: 5
DOI: 10.1520/D6828-02R24
ICS Code: 59.080.30