This specification covers the requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded sheet, rod and tubular bar manufactured from Poly(Vinylidene Fluoride) (PVDF). The type of PVDF shape product may be categorized by type, grade and class depending on resin and filler compositions. Each type of shape may be categorized into one of several grades as follows: Grade 1 - unmodified virgin-extruded or compression molded product made using only 100 % virgin PVDF material; Grade 2 - general purpose-extruded or compression molded product made using up to 20 % PVDF regrind developed during internal processing steps may be used; and Grade 3 - recycled-extruded or compression molded product made using up to 100 % recycled PVDF resin. The type, class and grade is further differentiated based on dimensional stability (elevated temperature excursion test), and dimensional requirements. Materials shall be tested and the individual grades shall conform to specified values of the physical properties such as tensile strength, tensile elongation, tensile modulus, dimensional stability, flexural modulus, and Izod impact; and dimensional properties such as diameter tolerance, roundness, camber, thickness tolerance, length camber, and width bow.
1.1 This specification covers the requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded sheet, rod and tubular bar manufactured from PVDF.
1.2 The properties included in this specification are those required for the compositions covered. Requirements necessary to identify particular characteristics important to specialized applications are described by using the classification system given in Section .
1.3 The values stated in English units are to be regarded as the standard in all property and dimensional tables. For reference purposes, SI units are also included in Tables X and S-PVDF only.
1.4 The following safety hazards caveat pertains only to the test method or test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard. ISO 12086-1 and ISO 12086-2 have pertinent information.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.