Standard Active Last Updated: Jan 17, 2018
ASTM D6705/D6705M-04(2018)

Standard Guide for Repair and Recoat of Spray Polyurethane Foam Roofing Systems

Significance and Use

4.1 This guide outlines general procedures and precautions necessary for correct and safe repair and recoat of SPF roofing systems.

4.2 This guide is not all inclusive; this guide is intended to supplement detailed instructions from manufacturers and safety requirements required by law.

Scope

1.1 This guide covers the procedures for the repair and recoating of existing spray polyurethane roofing systems.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.06
Pages: 3
DOI: 10.1520/D6705_D6705M-04R18
ICS Code: 83.100; 91.060.20