Standard Active Last Updated: Jan 09, 2020 Track Document
ASTM D6703-19

Standard Test Method for Automated Heithaus Titrimetry

Standard Test Method for Automated Heithaus Titrimetry D6703-19 ASTM|D6703-19|en-US Standard Test Method for Automated Heithaus Titrimetry Standard new BOS Vol. 04.03 Committee D04
$ 69.00 In stock

Significance and Use

5.1 This test method is intended as a laboratory diagnostic tool for estimating the colloidal stability of bitumen asphalt, asphalt cross blends, aged asphalt, and heavy oil residuum. Historically, bituminous asphalt and heavy oil residua have been modeled as colloidal suspensions in which a polar associated asphaltene moiety (the dispersed phase) is suspended in a maltene solvent moiety (the dispersing medium) (refer to Test Methods D3279 and D4124 for further definition of asphalt fraction materials). The extent to which these two moieties remain in state of peptization is a measure of the compatibility (colloidal stability) of the suspension. Compatibility may influence the physical properties of these materials, including rheological properties, for example, phase angle and viscosity. This test method and other similar test methods, along with the classical Heithaus test, may be recommended as a measure of the overall compatibility of a colloidal system by determining a parameter referred to as the state of peptization, P. The value of P commonly varies between 2.5 to 10 for unmodified or neat asphalts. Materials calculated to have low values of P are designated incompatible. Materials calculated to have high P values are designated compatible. Values in P are calculated as a function of two parameters that relate to the peptizability of the asphaltene moiety (the asphaltene peptizability parameter, pa) and the solvent power of the maltene moiety (the maltene peptizing power parameter, po). Values of pa and po are calculated as functions of the quantities Cmin and FRmax. Values of Cmin and FRmax are determined from experimental variables, the weight of asphalt (Wa), the volume of solvent (VS) to dissolve the weight of asphalt, and the volume of titrant (VT) added to initiate flocculation.

Scope

1.1 This test method describes a procedure for quantifying three Heithaus compatibility parameters that quantify the colloidal stability of asphalts and asphalt cross blends and aged asphalts.

1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.47
Pages: 9
DOI: 10.1520/D6703-19
ICS Code: 17.060