Standard Active Last Updated: Nov 06, 2020 Track Document
ASTM D6608-20

Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes

Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes D6608-20 ASTM|D6608-20|en-US Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes Standard new BOS Vol. 04.03 Committee D04
$ 55.00 In stock

Significance and Use

4.1 Asphalt contains sulfur compounds, most of which are removed during refining; the resulting asphalt also contains sulfur compounds which are released at the temperatures above 230 °C. Trinidad Lake Modified Asphalt contains sulfur compounds which are released at lower temperatures between 170 °C and 230 °C. The release of sulfur from Trinidad Lake Modified Asphalt tarnishes the copper strip and appears to be related directly to the total TLA content. The copper strip test is designed to assess the qualitative presence of TLA in asphalt.

Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.


1.1 This practice shall be used for the qualitative determination of Trinidad Lake Asphalt in Trinidad Lake Modified Asphalt Cements obtained from production blends or recovered binder from asphalt paving mixtures.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This practice is limited to asphalt binders which are produced in accordance with Specification D5710/D5710M.

1.4 Warning—Mercury has been designated by the United States Environmental Protection Agency and many state agencies as a hazardous material that can cause central nervous system, kidney, and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury-containing products. See the applicable Material Safety Data Sheet (MSDS) for details and EPA’s website——for additional information. Users should be aware that selling mercury and/or mercury-containing products into your state may be prohibited by state law.

1.5 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.47
Pages: 3
DOI: 10.1520/D6608-20
ICS Code: 93.080.20