Standard Active Last Updated: Oct 12, 2022 Track Document
ASTM D6495/D6495M-18(2022)

Standard Guide for Acceptance Testing Requirements for Geosynthetic Clay Liners

Standard Guide for Acceptance Testing Requirements for Geosynthetic Clay Liners D6495_D6495M-18R22 ASTM|D6495_D6495M-18R22|en-US Standard Guide for Acceptance Testing Requirements for Geosynthetic Clay Liners Standard new BOS Vol. 04.13 Committee D35
$ 55.00 In stock

Abstract

This guide covers guidelines for the acceptance testing requirements for geosynthetic clay liner (GCL) materials, describing types of tests, test methods, and recommended verifications and is intended to aid purchasers, installers, contractors, owners, operators, designers and agencies in establishing a minimum level of effort for product acceptance testing and verification. This guide suggests the types of tests, the methods of the testing, and verification requirements for acceptance testing of GCL materials. It should be recognized that parties, organizations or representatives may perform additional tests and/or at other frequencies than required in this standard guide. In this case, the project-specific acceptance plan will then take precedence over this standard guide. Different properties such as clay mass per unit area, swell index, fluid loss, grab tensile strength, tensile strength, density and thickness of geomembrane support, and bonding peel strength shall be determined by subjecting the material to different test methods.

Scope

1.1 This guide covers guidelines for the acceptance testing requirements for geosynthetic clay liner (GCL) materials, describing types of tests, test methods, and recommended verifications.

1.2 This guide is intended to aid purchasers, installers, contractors, owners, operators, designers, and agencies in establishing a minimum level of effort for product acceptance testing and verification. This is intended to ensure that the supplied GCL rolls meet accepted material specifications.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4 This guide offers an organized collection of information or a series of options and does not recommend a specific course of action. This guide cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this guide may be applicable in all circumstances. This guide is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this guide be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this guide means only that the guide has been approved through the ASTM consensus process.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.13
Developed by Subcommittee: D35.04
Pages: 4
DOI: 10.1520/D6495_D6495M-18R22
ICS Code: 91.100.50