Standard Historical Last Updated: Dec 06, 2023 Track Document
ASTM D6251/D6251M-19

Standard Specification for Wood-Cleated Panelboard Shipping Boxes

Standard Specification for Wood-Cleated Panelboard Shipping Boxes D6251_D6251M-19 ASTM|D6251_D6251M-19|en-US Standard Specification for Wood-Cleated Panelboard Shipping Boxes Standard new BOS Vol. 15.10 Committee D10
$ 83.00 In stock
ASTM International

Abstract

This specification covers the fabrication and closure of empty and full wood-cleated, hereafter referred to as wood-cleated, panelboard boxes. These boxes are intended for use as containers for domestic and overseas shipment of general materials and supplies. The box shall be classified according to box type: Type I; Type II; Type II; and Type IV. According to class: Class 1 and Class 2. According to style: Style A; Style A1; Style B; Style C through K. According to preservative treatment; Treatment A and Treatment B. And according to load type: Type 1; Type 2; and Type 3. Panels shall be fabricated by nailing, stapling, or gluing panelboard to cleats placed. Fastener component test, fastener test for securing cleats to panelboard panels; lateral resistance test; direct withdrawal resistance test; oxine copper preservative test; zinc napthenate preservative test; and preservative dryness test shall be performed to conform to the specified requirements.

Scope

1.1 This specification covers the fabrication and closure of empty and full wood-cleated, hereafter referred to as wood-cleated, panelboard boxes. These boxes are intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding 1000 lb [454 kg] depending on box type (see 10.1).

1.2 Wood-cleated panelboard shipping box performance is dependent on its fabricated components and subsequent assembly; therefore, a variety of types, classes, styles, and treatments reflecting varied performance are specified. This specification, however, does not cover wood-cleated panelboard box performance under all atmospheric, handling, shipping, and storage conditions.

1.3 If the use of other construction methods or techniques is acceptable and permitted (see 5.1.17), the resulting packaging systems shall be of equal or better performance than would result from the use of these specified materials and procedures. The appropriate distribution cycle, specified in Practice D4169, can be used to develop comparative procedures and criteria.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. See IEEE/ASTM SI 10 for conversion of units.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.10
Developed by Subcommittee: D10.12
Pages: 17
DOI: 10.1520/D6251_D6251M-19
ICS Code: 55.160