Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D5948-96(2002)e1

Standard Specification for Molding Compounds, Thermosetting

Standard Specification for Molding Compounds, Thermosetting D5948-96R02E01 ASTM|D5948-96R02E01|en-US Standard Specification for Molding Compounds, Thermosetting Standard new BOS Vol. 08.03 Committee D20
$ 83.00 In stock

Scope

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1and Annex A1-Annex A8).

Resin
Phenolic, cellulose filled
Phenolic, mineral/glass filled
Melamine
Polyester
Diallyl iso-phthalate
Diallyl ortho-phthalate
Silicone
Epoxy

Note 1—There is no equivalent ISO standard.

1.3 Order of Precedence—In the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.03
Developed by Subcommittee: D20.16
Pages: 18
DOI: 10.1520/D5948-96R02E01
ICS Code: 83.040.01