Standard Historical Last Updated: Dec 31, 2010
ASTM D5629-05

Standard Test Method for Polyurethane Raw Materials Determination of Acidity in Low-Acidity Aromatic Isocyanates and Polyurethane Prepolymers

Significance and Use

This test method can be used for research or for quality control to characterize aromatic isocyanates and low-acidity prepolymers. Acidity correlates with performance in some polyurethane systems.

Scope

1.1 This test method measures the acidity, expressed as ppm of hydrochloric acid (HCl), in aromatic isocyanate or polyurethane prepolymer samples of below 100 ppm acidity. The test method is applicable to products derived from toluene diisocyanate and methylene-bis-(4-phenylisocyanate) (see Note 0). Refer to Test Method D 6099 for determination of acidity in moderate- to high-acidity aromatic isocyanates.ISO 14898, Method B is technically equivalent to this test method.

1.2 The values stated in SI units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.03
Developed by Subcommittee: D20.22
Pages: 3
DOI: 10.1520/D5629-05
ICS Code: 83.080.10