Standard Historical Last Updated: Jan 11, 2012 Track Document
ASTM D5344-99(2005)

Standard Test Method for Extension Force of Partially Oriented Yarn

Standard Test Method for Extension Force of Partially Oriented Yarn D5344-99R05 ASTM|D5344-99R05|en-US Standard Test Method for Extension Force of Partially Oriented Yarn Standard new BOS Vol. 07.02 Committee D13
$ 83.00 In stock

Significance and Use

This test method is considered satisfactory for acceptance testing of commercial shipments because current estimates of between-laboratory precision are acceptable and the method is used extensively in the trade for acceptance testing.

5.1.1 If there are differences or practical signficance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples to be used are as homogeneous as possible, are drawn from the material from which the disparate test results are obtained, and are assigned randomly in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.

Elapsed time between spinning and testing has a marked effect on the results of the draw tension test, especially during the first 24 h. Therefore, if tested within 24 h of spinning, specimens should be compared only if tested after the same elapsed time. No specimen should be tested within 4 h of spinning because the aging process is at its most rapid rate during this period, and the differences in rate due to fiber structure are most pronounced.

The extension force of manufactured filament yarns is related to the alignment of the molecules in the yarn filaments, which influences the yarn processing behavior. Knowledge of this property of partially oriented yarn is useful to determine processing conditions.

Scope

1.1 This test method covers the measurement of extension force developed while drawing a partially oriented filament yarn.

1.2 This test method provides an estimate of the yarn orientation by means of continuous drawing of the yarn while running between pairs of draw rolls of different surface speeds.

1.3 This test method applies to partially oriented filament yarns less than 33.3 tex (300 denier), but it can be used for higher deniers by applying the test conditions as directed in Appendix X1.

1.4 This test method was written in SI units. The inch-pound units that are provided in this test method are not necessarily exact equivalents of the SI units. Either system of units may be used in this test method. In case of reference decisions, the SI units will prevail.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.02
Developed by Subcommittee: D13.58
Pages: 6
DOI: 10.1520/D5344-99R05
ICS Code: 59.080.20