Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D5191-06

Standard Test Method for Vapor Pressure of Petroleum Products (Mini Method)

Standard Test Method for Vapor Pressure of Petroleum Products (Mini Method) D5191-06 ASTM|D5191-06|en-US Standard Test Method for Vapor Pressure of Petroleum Products (Mini Method) Standard new BOS Vol. 05.02 Committee D02
$ 83.00 In stock

Scope

1.1 This test method covers the use of automated vapor pressure instruments to determine the total vapor pressure exerted in vacuum by air-containing, volatile, liquid petroleum products. This test method is suitable for testing samples with boiling points above 0C (32F) that exert a vapor pressure between 7 and 130 kPa (1.0 and 18.6 psi) at 37.8°C (100°F) at a vapor-to-liquid ratio of 4:1. Measurements are made on liquid sample sizes in the range from 1 to 10 mL. No account is made for dissolved water in the sample. Note 1Samples can also be tested at other vapor-to-liquid ratios, temperatures, and pressures, but the precision and bias statements need not apply.

Note 2

The interlaboratory studies conducted in 1988, 1991, and 2003 to determine the precision statements in Test Method D 5191 did not include any crude oil in the sample sets. Test Method D 6377, as well as IP 481, have been shown to be suitable for vapor pressure measurements of crude oils.

1.1.1 Some gasoline-oxygenate blends may show a haze when cooled to 0 to 1°C. If a haze is observed in 8.5, it shall be indicated in the reporting of results. The precision and bias statements for hazy samples have not been determined (see Note 14).

1.2 This test method is suitable for calculation of the dry vapor pressure equivalent (DVPE) of gasoline and gasoline-oxygenate blends by means of a correlation equation (see Eqn. 1 in ). The calculated DVPE very closely approximates the dry vapor pressure that would be obtained on the same material when tested by Test Method D 4953.

1.3 The values stated in SI units are regarded as standard. The inch-pound units given in parentheses are provided for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific safety warning statements, see 7.2 through 7.8.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.02
Developed by Subcommittee: D02.08
Pages: 8
DOI: 10.1520/D5191-06
ICS Code: 75.080