Standard Historical Last Updated: Nov 06, 2024 Track Document
ASTM D5147/D5147M-18

Standard Test Methods for Sampling and Testing Modified Bituminous Sheet Material

Standard Test Methods for Sampling and Testing Modified Bituminous Sheet Material D5147_D5147M-18 ASTM|D5147_D5147M-18|en-US Standard Test Methods for Sampling and Testing Modified Bituminous Sheet Material Standard new BOS Vol. 04.04 Committee D08
$ 83.00 In stock
ASTM International

Significance and Use

3.1 These test methods are used for sampling and testing modified bitumen sheet materials. Property requirements, determined by these test methods, are found in the following product standards: Specifications D6162/D6162M, D6163/D6163M, D6164/D6164M, D6222/D6222M, D6223/D6223M, D6298/D6298M, and D6509/D6509M.

Abstract

These test methods cover procedures for sampling and testing prefabricated, reinforced, polymer-modified bituminous sheet materials designed for single- or multiple-ply application in roofing and waterproofing membranes. From each shipment or fraction thereof, select at random a number of rolls equal to one half the cube root of the total number of rolls in the lot. If the calculated number is fractional, express it as the next highest whole number. The load strain (tensile elongation and strain energy) properties shall be tested to meet the requirements prescribed. The tensile tear strength, moisture content, and water absorption of polymer-modified bituminous sheets shall be tested to meet the requirements prescribed. The dimensional stability, low-temperature flexibility, heat conditioning, and accelerated weathering of the polymer-modified bituminous sheets shall be tested to meet the requirements prescribed. The granule embedment, compound stability, coating thickness, low temperature unrolling, and precision and bias of the polymer-modified bituminous sheet materials shall be tested to meet the requirements prescribed.

Scope

1.1 These test methods cover procedures for sampling and testing prefabricated, reinforced, polymer-modified bituminous sheet materials designed for single- or multiple-ply application in roofing and waterproofing membranes. These products may use various surfacing materials on one side.

1.2 These test methods cover a number of different products. Not all tests are required for every product. Only those called out in the Product Standard are required.

1.3 These test methods appear in the following order:

 

Section

 

 

Sampling

4

Conditioning

5

Thickness

6

Load Strain Properties

7

Tear Strength

8

Moisture Content

9

Water Absorption

10

Dimensional Stability

11

Low-Temperature Flexibility

12

Heat Conditioning

13

Accelerated Weathering

14

Granule Embedment

15

Compound Stability

16

Coating Thickness

17

Low Temperature Unrolling

18

Precision and Bias

19

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.04
Pages: 8
DOI: 10.1520/D5147_D5147M-18
ICS Code: 91.100.50