Standard Active Last Updated: Jan 31, 2018 Track Document
ASTM D5117-17

Standard Test Method for Dye Penetration of Solid Fiberglass Reinforced Pultruded Stock

Standard Test Method for Dye Penetration of Solid Fiberglass Reinforced Pultruded Stock D5117-17 ASTM|D5117-17|en-US Standard Test Method for Dye Penetration of Solid Fiberglass Reinforced Pultruded Stock Standard new BOS Vol. 08.03 Committee D20
$ 55.00 In stock

Significance and Use

5.1 This test method is useful for establishing the integrity of composite rod. The presence of voids, cracks, and hollow fibers are considered detrimental to the structural integrity of the composite and causes reduced electrical resistance and increased current leakage.

5.2 A perfect composite would be flaw-free, and there would be no possibility of wicking. Composites of this type are virtually nonexistent, as there will typically be entrapped air in the resin developed during manufacturing, occasional hollow fibers, and occasional cracks due to thermal stresses.

5.3 This test method is intended to provide a tool for measuring the extent of wicking in a composite over very short lengths of material for comparative purposes. The presence of wicking over 1 in. (2.54 cm) lengths will not necessarily imply that the composite will perform unsatisfactorily for its intended end-use. Therefore, interpretation of test results shall be made carefully.

5.4 This test method was developed as a technique for estimating quality and consistency of pultruded rod and bar stock, which is a composite of resin and all-roving reinforcement. This test method will be useful for a manufacturer to determine whether any gross changes in quality have taken place due to process or raw material changes as the manufacturing process also affects the quality of the product.

5.5 Since the results of this test are so sensitive to sample size, penetrant type, penetrant used, viscosity, duration of test, and other factors, no attempt to arrive at or recommend development of a specification for these materials has been made. A specification shall be negotiated between supplier and end user and such specification shall be made with great care.


1.1 This dye-penetrant test method covers a means of evaluating solid fiberglass all-roving reinforced pultruded rod or bar stock for longitudinal wicking. There are generally three mechanisms that promote wicking such as delaminations, longitudinal continuous voids, or the presence of hollow fibers. Any or all of them will be operating at a given time.

Note 1: Occasionally the flaws listed above may be detected by this test, but other tests are usually required.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 10.3 and 10.6.

Note 2: There is no known ISO equivalent to this test method.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 08.03
Developed by Subcommittee: D20.18
Pages: 4
DOI: 10.1520/D5117-17
ICS Code: 83.120