Standard Withdrawn, Replaced Replaced By: D7430    Last Updated: Dec 31, 2010 Track Document
ASTM D4916-04

Standard Practice for Mechanical Auger Sampling (Withdrawn 2008)

Standard Practice for Mechanical Auger Sampling (Withdrawn 2008) D4916-04 ASTM|D4916-04|en-US Standard Practice for Mechanical Auger Sampling (Withdrawn 2008) Standard new BOS Vol. 05.06 Committee D05
$ 0.00 Out of stock

Scope

1.1 This practice describes procedures for the collection of an increment, partial sample, or gross sample of material using mechanical augers. Reduction and division of the material by mechanical equipment at the auger is also covered. Further manual or mechanical reduction or division of the material elsewhere shall be performed in accordance with Method D 2013.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center