Standard Active Last Updated: Oct 22, 2024 Track Document
ASTM D4682-18(2024)

Standard Specification for Miscibility with Gasoline and Fluidity of Two-Stroke-Cycle Gasoline Engine Lubricants

Standard Specification for Miscibility with Gasoline and Fluidity of Two-Stroke-Cycle Gasoline Engine Lubricants D4682-18R24 ASTM|D4682-18R24|en-US Standard Specification for Miscibility with Gasoline and Fluidity of Two-Stroke-Cycle Gasoline Engine Lubricants Standard new BOS Vol. 05.02 Committee D02
$ 69.00 In stock
ASTM International

Abstract

This standard specification describes four categories of two-stroke-cycle gasoline engine lubricants based on their miscibility with gasoline and their low-temperature fluidity. The lubricant categories are classified according to the temperature at which the tests are conducted. The lubricants shall meet the requirements for viscosity and miscibility with gasoline. Miscibility test method shall be done using a rotator, graduated cylinders, stoppered flask, and freezer, and shall use reference oil and any full-boiling-range gasoline as indicated in the specification. Fluidity test method shall be done using Brookfield viscometer and its associated equipment. All test method shall be in accordance with the calibration and standardization procedure indicated in the specification.

Scope

1.1 This specification covers four categories of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines based on their miscibility with gasoline and their low-temperature fluidity.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.02
Developed by Subcommittee: D02.B0.07
Pages: 5
DOI: 10.1520/D4682-18R24
ICS Code: 75.160.20