Standard Historical Last Updated: Nov 18, 2021 Track Document
ASTM D4302-14

Standard Specification for Artists’ Oil, Resin-Oil, and Alkyd Paints

Standard Specification for Artists’ Oil, Resin-Oil, and Alkyd Paints D4302-14 ASTM|D4302-14|en-US Standard Specification for Artists’ Oil, Resin-Oil, and Alkyd Paints Standard new BOS Vol. 06.02 Committee D01
$ 83.00 In stock

Significance and Use

4.1 This specification establishes quality requirements and provides a basis for common understanding among producers, distributors, and users.

4.2 It is not intended that all paints meeting the requirements be identical nor of uniform excellence in all respects. Variations in manufacture, not covered by this specification, may cause some artists to prefer one brand over another, either of which may be acceptable under this specification.

Abstract

This specification establishes requirements for composition, physical properties, performance, and labeling of artists' oil, resin-oil, and alkyd paints. This specification covers pigments, vehicles, and additives. Requirements are included for pigment identification, lightfastness, consistency, and drying time. The different labelling requirements for artists' oil paints, resin-oil, and alkyd paints are presented in details. The quality assurance method for artists' oil paints and artists' resin-oil paints are presented in details. The quality assurance methods for artists' alkyd paints are presented. The lightfastness of the paints shall be tested to meet the requirements prescribed. Lightfastness categories shall be assign to meet the requirements prescribed.

Scope

1.1 This specification establishes requirements for composition, physical properties, performance, and labeling of artists’ oil, resin-oil, and alkyd paints.

1.2 This specification covers pigments, vehicles, and additives. Requirements are included for pigment identification, lightfastness, consistency, and drying time.

1.3 Table 1 lists some pigments meeting the lightfastness requirements in this specification. In order to identify other pigments that meet these requirements, instructions are given for test specimen preparation. Test methods for determining relative lightfastness are referenced.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.5 This pertains only to the test method found in Section 8.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 06.02
Developed by Subcommittee: D01.57
Pages: 10
DOI: 10.1520/D4302-14
ICS Code: 87.040; 97.195