Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D3796-90(1998)

Standard Practice for Calibration of Type S Pitot Tubes

Standard Practice for Calibration of Type S Pitot Tubes D3796-90R98 ASTM|D3796-90R98|en-US Standard Practice for Calibration of Type S Pitot Tubes Standard new BOS Vol. 11.07 Committee D22
$ 83.00 In stock


1.1 This practice covers the determination of Type S pitot tube coefficients in the gas velocity range from 305 to 1524 m/min or 5.08 to 25.4 m/s (1000 to 5000 ft/min). The method applies both to the calibration of isolated Type S pitot tubes (see 5.1), and pitobe assemblies (see 5.2).

1.2 This practice outlines procedures for obtaining Type S pitot tube coefficients by calibration at a single-velocity setting near the midpoint of the normal working range (see 5.3). Type S pitot coefficients obtained by this method will generally be valid to within +3% over the normal working range. If a more precise correlation between Type S pitot tube coefficient and velocity is desired, multivelocity calibration technique (Annex A1) should be used.

1.3 This practice may be used for the calibration of thermal anemometers for gas velocities in excess of 3 m/s (10 ft/s).

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 11.07
Developed by Subcommittee: D22.01
Pages: 13
DOI: 10.1520/D3796-90R98
ICS Code: 17.020