Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D3775-07a

Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics

Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics D3775-07A ASTM|D3775-07A|en-US Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics Standard new BOS Vol. 07.01 Committee D13
$ 73.00 In stock

Significance and Use

This test method is considered satisfactory for acceptance testing of commercial shipments because it has been used extensively in the trade for that purpose.

If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.

Scope

1.1 This test method covers the measurement of warp end count and filling pick count and is applicable to all types of woven fabrics.

Note 1—Historically, the term fabric count has been used to describe the end and pick count of woven fabrics. The terms warp (end) and filling (pick) count are replacing the term fabric count, to provide clarity.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.60
Pages: 4
DOI: 10.1520/D3775-07A
ICS Code: 59.080.30