Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D3767-01

Standard Practice for Rubber-Measurement of Dimensions

Standard Practice for Rubber-Measurement of Dimensions D3767-01 ASTM|D3767-01|en-US Standard Practice for Rubber-Measurement of Dimensions Standard new BOS Vol. 09.01 Committee D11
$ 75.00 In stock

Scope

1.1 This practice is intended for use in determining the geometrical dimensions of rubber products and specimens for physical tests. This practice describes procedures for determining length, width, thickness, diameter, and circumference. This practice does not cover sampling of materials or products, or locations where a sample is to be taken.

1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as a standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any other way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D11.10
Pages: 7
DOI: 10.1520/D3767-01
ICS Code: 83.060