Standard Active Last Updated: Nov 09, 2023 Track Document
ASTM D3737-18(2023)e1

Standard Practice for Establishing Allowable Properties for Structural Glued Laminated Timber (Glulam)

Standard Practice for Establishing Allowable Properties for Structural Glued Laminated Timber (Glulam) D3737-18R23E01 ASTM|D3737-18R23E01|en-US Standard Practice for Establishing Allowable Properties for Structural Glued Laminated Timber (Glulam) Standard new BOS Vol. 04.10 Committee D07
$ 108.00 In stock
ASTM International

Abstract

This practice details the standard procedures for establishing the allowable properties for structural glued laminated timber (glulam). Allowable properties include: stress indexes; stress modification factors associated with slop of grain; stresses for bending, tension and compression parallel to the grain; horizontal shear; compression perpendicular to the grain; radial tension and compression stresses in curved members; grade adjustment factors; modulus of elasticity; and modulus of rigidity. This practice is limited to the calculation of allowable properties subject to the given procedures for the selection and arrangement of grades of lumber of the species considered. It does not cover the requirements for production, inspection and certification, but in order to justify the allowable properties developed using procedures in this practice, manufacturers must conform to recognized manufacturing standards.

Scope

1.1 This practice covers the procedures for establishing allowable properties for structural glued laminated timber. Included are the allowable stresses for bending, tension and compression parallel to the grain, horizontal shear, compression perpendicular to the grain, and radial tension and compression in curved members. Also included are modulus of elasticity and modulus of rigidity.

1.2 This practice is limited to the calculation of allowable properties subject to the given procedures for the selection and arrangement of grades of lumber of the species considered.

1.3 Requirements for production, inspection and certification are not included, but in order to justify the allowable properties developed using procedures in this practice, manufacturers must conform to recognized manufacturing standards. Refer to ANSI A190.1 and CSA O122.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in SI units are mathematical conversions that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.10
Developed by Subcommittee: D07.02
Pages: 41
DOI: 10.1520/D3737-18R23E01
ICS Code: 79.060.01