Standard Historical Last Updated: Mar 19, 2014 Track Document
ASTM D3657-03(2009)

Standard Specification for Zipper Dimensions

Standard Specification for Zipper Dimensions D3657-03R09 ASTM|D3657-03R09|en-US Standard Specification for Zipper Dimensions Standard new BOS Vol. 07.01 Committee D13
$ 73.00 In stock

Abstract

This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths. Size, zipper length, tape width, and tape end length tests shall be performed in accordance with the specified requirements.

Scope

1.1 This specification establishes standard dimensions for zippers of all materials for specified size designation; for equivalency, in inch-pound and metric units, of zipper length and length tolerances, of tape width and width tolerances, and of tape end lengths.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.54
Pages: 2
DOI: 10.1520/D3657-03R09
ICS Code: 61.040