Standard Active Last Updated: Mar 18, 2022 Track Document
ASTM D3368-17(2022)

Standard Specification for FEP Sheet and Film

Standard Specification for FEP Sheet and Film D3368-17R22 ASTM|D3368-17R22|en-US Standard Specification for FEP Sheet and Film Standard new BOS Vol. 08.02 Committee D20
$ 63.00 In stock


This specification covers unfilled, unpigmented FEP-fluorocarbon resin sheet and film. The sheet and film shall be made from FEP-fluorocarbon resin without filler or plasticizer. This specification allows for the use of recycled, reprocessed, and reworked FEP materials provided that: the final physical, mechanical, and performance requirements are met; and the toxicological characteristics are essentially unaltered from that of virgin material. The tensile strength, elongation at break, dimensional change on heating, cementability, dielectric strength, and density of the sheet and film shall be tested.


1.1 This specification covers unfilled, unpigmented FEP resin sheet and film less than 3.175 mm (0.125 in.) thick. Recycled materials are allowed in accordance with 6.2.

1.2 The values stated in SI units as detailed in IEEE/ASTM SI 10 are to be regarded as standard and the practices of IEEE/ASTM SI 10 incorporated herein.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 08.02
Developed by Subcommittee: D20.15
Pages: 6
DOI: 10.1520/D3368-17R22
ICS Code: 83.140.10