Standard Active Last Updated: Oct 18, 2022 Track Document
ASTM D3194-17(2022)

Standard Test Method for Rubber From Natural Sources—Plasticity Retention Index (PRI)

Standard Test Method for Rubber From Natural Sources—Plasticity Retention Index (PRI) D3194-17R22 ASTM|D3194-17R22|en-US Standard Test Method for Rubber From Natural Sources—Plasticity Retention Index (PRI) Standard new BOS Vol. 09.01 Committee D11
$ 61.00 In stock
ASTM International

Significance and Use

4.1 This test method may be used to evaluate the heat and/or oxidation stability (aging) of raw rubber under controlled conditions. High original and aged plasticity values usually correspond to good aging properties. The ratio of the aged to original plasticity values expressed as a percentage, the PRI, is used as an indication of aging.

Scope

1.1 This test method gives an indication of the oxidation resistance of raw natural rubber at a specified temperature. This resistance is indicated by the Plasticity Retention Index (PRI), a ratio expressed as a percentage of the aged plasticity to the original plasticity determined by means of a parallel plate plastometer. A low PRI value indicates a poor resistance to oxidation.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D11.22
Pages: 4
DOI: 10.1520/D3194-17R22
ICS Code: 83.040.10