Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D3123-98(2004)

Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds

Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds D3123-98R04 ASTM|D3123-98R04|en-US Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds Standard new BOS Vol. 08.01 Committee D20
$ 73.00 In stock

Significance and Use

The spiral flow of a thermosetting molding compound is a measure of the combined characteristics of fusion under pressure, melt viscosity, and gelation rate under specific conditions.

This test method is useful as a quality control test and as an acceptance criterion.

This test method, by itself, is not a valid means for comparing the moldability of similar or different molding compounds because it cannot duplicate actual conditions prevalent in different types of production molds.

This test method is presently intended for use at a transfer pressure of 6.9 MPa [1000 psi] and a mold temperature of 423 ± 3 K (150 ± 3°C [302 ± 5°F]).

Scope

1.1 This test method covers a procedure for measuring the spiral flow of thermosetting molding compounds (soft or very soft) designed for molding pressures under 6.9 MPa [1000 psi]. It is especially suited for those compounds that may be used for encapsulation or other low pressure molding techniques. Textile-reinforced compounds should not be tested using this test method. It involves the use of a standard spiral flow mold in a transfer molding press under specified conditions of applied temperature and pressure with a controlled charge mass.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

There is no equivalent ISO standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.30
Pages: 3
DOI: 10.1520/D3123-98R04
ICS Code: 83.140.99