Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D3122-95(2002)

Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings

Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings D3122-95R02 ASTM|D3122-95R02|en-US Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings Standard new BOS Vol. 08.04 Committee F17
$ 73.00 In stock

Abstract

This specification provides general requirements for styrene-rubber solvent cements used in joining styrene-rubber (SR) plastic pipe and fittings. A recommended procedure for joining styrene-rubber pipe and fittings is given. The materials shall meet the required resin content, dissolution, viscosity, and lap shear strength.

Scope

1.1 This specification provides general requirements for styrene-rubber solvent cements to be used in joining styrene-rubber (SR) plastic pipe and fittings.

1.2 A recommended procedure for joining styrene-rubber pipe and fittings is given in the appendix.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.04
Developed by Subcommittee: F17.20
Pages: 4
DOI: 10.1520/D3122-95R02
ICS Code: 83.180