Standard Historical Last Updated: Aug 16, 2017
ASTM D3065-01

Standard Test Methods for Flammability of Aerosol Products

Standard Test Methods for Flammability of Aerosol Products
$ 60.00 In stock


1.1 These test methods cover the determination of flammability hazards for aerosol products.

1.2 These test methods appear in the following order:

Flame Projection Test4 to 7
Closed Drum Test8 to 10

1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 15.10
Developed by Subcommittee: D10.33
Pages: 3
DOI: 10.1520/D3065-01
ICS Code: 55.130