Standard Withdrawn, No replacement   Last Updated: Jan 06, 2022
ASTM D2987/D2987M-88(2019)

Standard Test Method for Moisture Content of Asbestos Fiber (Withdrawn 2022)

Significance and Use

4.1 This test method will give a value of moisture content obtained under specified conditions. This value should not be considered as an absolute moisture content. Results may not compare with those obtained by the same method under different conditions, or by different methods.

Scope

1.1 This test method covers the determination of the moisture content of asbestos fiber.

1.2 Warning—Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysotile asbestos, refer to “Safe Use of Chrysotile: A Manual on Preventive and Control Measures.”2

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center