Standard Historical Last Updated: Mar 02, 2021 Track Document
ASTM D2835-89(1998)

Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements

Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements D2835-89R98 ASTM|D2835-89R98|en-US Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements Standard new BOS Vol. 04.03 Committee D04
$ 66.00 In stock

Scope

1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement. For changes to this Standard since the last issue, refer to the Summary of Changes Section at the end of the Standard.

1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency and drying rate.

1.3 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S customary units may be approximate.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.34
Pages: 3
DOI: 10.1520/D2835-89R98
ICS Code: 93.080.10