Standard Historical Last Updated: Aug 16, 2017
ASTM D2829-04

Standard Practice for Sampling and Analysis of Built-Up Roofs

Standard Practice for Sampling and Analysis of Built-Up Roofs
$ 68.00 In stock


1.1 This practice is a guide for removing test specimens from built-up roofing systems in the field and for determining the approximate quantities of the components of that specimen (Note 0). Components determined may be:

1.1.1 Insulation components when they are part of the roof membrane system,

1.1.2 Plies of roofing felt,

1.1.3 Interply layers of bituminous material,

1.1.4 Top coating, and

1.1.5 Surfacing.

Note 1—This procedure is for the investigation of existing roofs and is not intended for new construction inspection.

1.2 This practice is applicable to 914-mm (36-in.) wide felt rolls only and does not apply to metric-sized (that is, 1000-mm (393/8-in.) wide) felt rolls.

1.3 The values stated in SI (metric) units are to be regarded as standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary information, see

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.20
Pages: 5
DOI: 10.1520/D2829-04
ICS Code: 91.100.50