Standard Active Last Updated: Jun 14, 2019 Track Document
ASTM D2827-19

Standard Specification for Styrene Monomer

Standard Specification for Styrene Monomer D2827-19 ASTM|D2827-19|en-US Standard Specification for Styrene Monomer Standard new BOS Vol. 06.04 Committee D16
$ 50.00 In stock


This specification covers styrene monomer. The purity, aldehydes, peroxides, polymer, inhibitor, ethylbenzene, water, and color shall be tested to meet the requirements specified.


1.1 This specification covers styrene monomer.

1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measure are included in this specification.

1.4 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 06.04
Developed by Subcommittee: D16.07
Pages: 2
DOI: 10.1520/D2827-19
ICS Code: 71.080.15