Standard Historical Last Updated: Jan 17, 2019 Track Document
ASTM D2724-07(2015)

Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics

Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics D2724-07R15 ASTM|D2724-07R15|en-US Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics Standard new BOS Vol. 07.01 Committee D13
$ 75.00 In stock

Significance and Use

5.1 These test methods for the determination of properties of bonded, fused, or laminated apparel fabrics, are considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics since the methods have been used extensively in the trade for acceptance testing.

5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.


1.1 These test methods cover procedures for characterizing the delamination, strength of bond, appearance, and shrinkage propensity of bonded, fused, and laminated apparel fabrics after drycleaning and laundering.

1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only.

1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.59
Pages: 7
DOI: 10.1520/D2724-07R15
ICS Code: 59.080.40