Standard Active Last Updated: Jul 04, 2024 Track Document
ASTM D2639/D2639M-24

Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer

Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer D2639_D2639M-24 ASTM|D2639_D2639M-24|en-US Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer Standard new BOS Vol. 05.06 Committee D05
$ 69.00 In stock
ASTM International

Significance and Use

5.1 Reliable values of the plastic properties of coals are used to predict or explain the behavior of a coal or blends during carbonization or in other processes such as gasification, liquefaction, and combustion.

Scope

1.1 This test method covers a relative measure of the plastic behavior of coal when heated under prescribed conditions. This test method may be used to obtain semiquantitative values of the plastic properties of coals and blends used in carbonization and in other situations where determination of plastic behavior of coals is of practical importance.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 In this test method, the term “mass” applies to measurements expressed with both SI units (for example, kg) and inch-pound units (for example, lb).

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.06
Developed by Subcommittee: D05.15
Pages: 7
DOI: 10.1520/D2639_D2639M-24
ICS Code: 75.160.10