Standard Historical Last Updated: Dec 31, 2010
ASTM D2562-94(2002)e1

Standard Practice for Classifying Visual Defects in Parts Molded from Reinforced Thermosetting Plastics

Abstract

This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding. Word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection are presented. Different inspection requirements for grades of product quality are categorized. Each part shall be checked visually without the aid of magnification. Defects shall be classified as to type and level as prescribed.

Scope

1.1 This practice covers acceptance criteria for visual inspection of parts molded from reinforced thermosetting plastics by compression and transfer molding.

1.2 This practice presents word descriptions of possible defects to serve as a guide for contracts, drawings, product specifications, and final inspection.

1.3 This practice also categorizes different inspection requirements for grades of product quality.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this practice.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.18
Pages: 5
DOI: 10.1520/D2562-94R02E01
ICS Code: 83.120