Standard Historical Last Updated: Jun 01, 2015 Track Document
ASTM D2266-01(2008)

Standard Test Method for Wear Preventive Characteristics of Lubricating Grease (Four-Ball Method)

Standard Test Method for Wear Preventive Characteristics of Lubricating Grease (Four-Ball Method) D2266-01R08 ASTM|D2266-01R08|en-US Standard Test Method for Wear Preventive Characteristics of Lubricating Grease (Four-Ball Method) Standard new BOS Vol. 05.01 Committee D02
$ 66.00 In stock

Significance and Use

The four-ball wear-test method can be used to determine the relative wear-preventing properties of greases under the test conditions and if the test conditions are changed the relative ratings may be different. No correlation has been established between the four-ball wear test and field service. The test method cannot be used to differentiate between Extreme Pressure (EP) and Non-Extreme Pressure (Non-EP) Greases.

Scope

1.1 This test method covers the determination of the wear preventive characteristics of greases in sliding steel-on-steel applications. It is not intended to predict wear characteristics with metal combinations other than steel-on-steel or to evaluate the extreme pressure characteristics of the grease.

1.2 The values stated in SI units are to be regarded as the standard except where the test apparatus or consumable parts are only available in other units. In such cases, these will be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.01
Developed by Subcommittee: D02.G0.04
Pages: 3
DOI: 10.1520/D2266-01R08
ICS Code: 75.100