Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D2259-02

Standard Test Method for Shrinkage of Yarns

Standard Test Method for Shrinkage of Yarns D2259-02 ASTM|D2259-02|en-US Standard Test Method for Shrinkage of Yarns Standard new BOS Vol. 07.01 Committee D13
$ 75.00 In stock


1.1 This test method is used to determine the shrinkage of yarns in skein form when treated in boiling water, dry heat, saturated steam, or solvents. This test method is applicable to yarns made from any fiber or combination of fibers where the tex of the yarn is known or can be determined. This test method is not recommended for elastomeric yarns and those yarns that stretch more than 5 % under the tension loadings prescribed, although it has been used for the latter.

Note 1—Procedures for determining yarn shrinkage and bulk properties of textured yarns are covered in Test Method D 4031.

1.2 This test method shows the values in both SI and inch-pound units. "SI" units is the technically correct name for the system of metric units known as the International System of Units. "Inch-pound" units is the technically correct name for the customary units used in the United States. The values stated in either SI units or in other units shall be regarded as standard. The values expressed in each system may not be exact equivalents; therefore each system must be used independently of the other without combining in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.58
Pages: 5
DOI: 10.1520/D2259-02
ICS Code: 59.080.20