Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D2172-95

Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures

Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures D2172-95 ASTM|D2172-95|en-US Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures Standard new BOS Vol. 04.03 Committee D04
$ 91.00 In stock

Scope

1.1 These test methods cover the quantitative determination of bitumen in hot-mixed paving mixtures and pavement samples. Aggregate obtained by these test methods may be used for sieve analysis using Test Method C 117 and Test Method C 136.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.

Note 1—The results obtained by these test methods may be affected by the age of the material tested, with older samples tending to yield slightly lower bitumen content. Best quantitative results are obtained when the test is made on mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt when some aggregates are used and some chlorides may remain within the mineral matter affecting the measured asphalt content.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.25
Pages: 12
DOI: 10.1520/D2172-95
ICS Code: 91.100.50; 93.080.20