Standard Historical Last Updated: Oct 25, 2022 Track Document
ASTM D2148-19e1

Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation

Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation D2148-19E01 ASTM|D2148-19E01|en-US Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation Standard new BOS Vol. 10.01 Committee D09
$ 75.00 In stock

Significance and Use

5.1 Self-adhesion is a primary initial property since it affects layer-to-layer bonding. The integrity of the bond can significantly affect the electrical and physical performance of the insulation system. Therefore, the degree of self-adhesion is directly related to apparatus performance.

5.2 A high degree of self-adhesion is desirable for most electrical applications. In this test, a short unwinding length indicates a high degree of self-adhesion.

5.3 This test method has been found useful as a quality control test for lot acceptance.

Scope

1.1 These test methods cover tests for bondable silicone rubber tapes which form a sealed structure either with the application of heat (and pressure if needed) or by the process of auto-adhesion (self-fusing).

1.2 These test methods appear in the following sections:

     Test Method

Section

 

 

     Adhesion

3 – 10

     Bond Strength

11 – 18

     Dielectric Breakdown Voltage

19 – 26

     Hardness

41

     Length

33 and 34

     Thickness

27 – 32

     Width

36 – 40

1.3 Units—The values stated in SI units are the standard. The inch-pound units in parentheses are for information only. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement see 23.1.1.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.01
Developed by Subcommittee: D09.07
Pages: 6
DOI: 10.1520/D2148-19E01
ICS Code: 29.035.20