Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D2060-00(2005)e1

Standard Test Methods for Measuring Zipper Dimensions

Standard Test Methods for Measuring Zipper Dimensions D2060-00R05E01 ASTM|D2060-00R05E01|en-US Standard Test Methods for Measuring Zipper Dimensions Standard new BOS Vol. 07.01 Committee D13
$ 75.00 In stock


1.1 These test methods cover the measurement of the dimensions of all types and sizes of zippers.

1.2 The test methods appear as follows:

Chain Flatness34-39
Chain Straightness40-44
Chain Thickness28-33
Length of Zipper or Parts9-14
Longitudinal Dimensional Change45-52
Slider Mouth Width21-27
Tape Width15-20

1.3 The values stated in either SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.54
Pages: 9
DOI: 10.1520/D2060-00R05E01
ICS Code: 61.040