Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D1921-06

Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials

Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials D1921-06 ASTM|D1921-06|en-US Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials Standard new BOS Vol. 08.01 Committee D20
$ 83.00 In stock

Significance and Use

These test methods can be used to determine particle size distribution and therefore are useful for determining lot-to-lot uniformity.

The particle sizes of plastic materials affect the handling characteristics and sometimes will affect the processing characteristics of some polymers.

Scope

1.1 These test methods cover the measurement of the particle size of plastic materials in the powdered, granular, or pelleted forms in which they are commonly supplied. As these test methods utilize dry sieving, the lower limit of measurement is considered to be about 38 m (No. 400 sieve). For smaller particle sizes, sedimentation test methods are recommended.

1.2 Two test methods are described:

1.2.1 Test Method AThis test method uses multiple sieves selected to span the particle size of the material. This method is used to determine the mean particle diameter and particle size distribution.

1.2.2 Test Method BThis test method is an abbreviated version of Test Method A conducted with a few specific sieves. This test method determines "percent passing" or "percent retained" on a given sieve. Test Method B is applicable to materials which do not have a normal particle size distribution such as pellets and cubes.

1.3 The values stated in SI units shall be considered standard for dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

There is no technically equivalent ISO standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.70
Pages: 5
DOI: 10.1520/D1921-06
ICS Code: 19.120