Standard Historical Last Updated: Nov 20, 2013
ASTM D1867-07

Standard Specification for Copper-Clad Thermosetting Laminates for Printed Wiring

Abstract

This specification covers twelve grades of thermosetting laminate with copper foil cladded to one or both surfaces. These combination forms are intended primarily for use in fabrication of printed (etched) wiring or circuit boards. The laminates shall meet the following requirements: peel strength after solder float and at elevated temperature conditions; lengthwise and crosswise flexural strengths; flammability rating; water absorption; volume resistivity; dielectric breakdown parallel to laminations; dissipation factor; and permittivity. Warp or twist, and blistering requirements shall also be tested for conformance.

Scope

1.1 This specification covers twelve grades of thermosetting laminate with copper foil bonded to one or both surfaces. These combination forms are intended primarily for use in fabrication of printed (etched) wiring or circuit boards.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.01
Developed by Subcommittee: D09.07
Pages: 5
DOI: 10.1520/D1867-07
ICS Code: 31.180