Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D1782-95(2009)

Standard Test Methods for Operating Performance of Particulate Cation-Exchange Materials

Standard Test Methods for Operating Performance of Particulate Cation-Exchange Materials D1782-95R09 ASTM|D1782-95R09|en-US Standard Test Methods for Operating Performance of Particulate Cation-Exchange Materials Standard new BOS Vol. 11.02 Committee D19
$ 75.00 In stock

Significance and Use

Cation exchange materials are frequently used in the sodium form to exchange divalent and trivalent ions in the influent water for sodium ions on the resin sites. This process is commonly referred to as softening water since it removes those ions that form a hard curd of insoluble salts with the fatty acids used in some soaps and that also precipitate when water is boiled. In such a process, sodium chloride is used as the regenerant to return the cation-exchanging groups to the sodium form.

This test method is intended to simulate the performance of such materials in actual usage. It may be used either to compare the performance of new materials or to compare the performance of a material that has been used with its original performance.

Regenerant concentrations and dosages used herein are typical for the types of materials used in this application. If different concentrations or amounts of regenerant are agreed upon by parties using this test method, this fact should be stated when the results are reported. Similarly, the test water specified is the agreed upon standard. Where other test waters or the water to be treated are used in the test, the analysis of the water in terms of total solids, sodium, calcium, magnesium, other di- or trivalent metals as well as the major anions present should be reported with the test results.

Scope

1.1 These test methods cover the determination of the operating capacity of particulate cation-exchange materials when used for the removal of calcium, magnesium, and sodium ions from water. It is intended for use in testing both new and used materials. The following two test methods are included:

Sections
Test Method ASodium Cycle 8 to 14
Test Method BHydrogen Cycle15 to 21

1.2 The values given in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

8.1 This test method is designed to simulate operating conditions on a sodium cycle used for the removal of calcium and magnesium and other divalent ions from water.

15.1 This test method is designed to simulate operating conditions on a hydrogen cycle used for the removal of all other cations from water.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 11.02
Developed by Subcommittee: D19.08
Pages: 6
DOI: 10.1520/D1782-95R09
ICS Code: 71.100.40